Chlorine vaporiser C 6100
*Illustration may differ from the actual product
Efficient gas generation
The zC 6100 vaporiser essentially consists of a tube coil with a vertical inlet and outlet. The tube coil is surrounded by a steel tank filled with water. Immersion heaters underneath the pipe coil, near the base of the tank, ensure that the water is heated evenly by free convection. There is no need for circulation pumps or mixers to circulate the water.
The liquid chlorine enters the evaporator from above and flows in countercurrent to the warm water circulating upwards through the pipe coil towards the bottom of the tank. On its way down, it absorbs the heat from the water and evaporates. The heat of the water is used effectively and efficiently to vaporise the liquid chlorine by moving the two liquids past each other.
Properties & advantages
- Evaporator capacity up to 220 kg Cl2/h
- Designed as a tube coil evaporator with water as the heating medium
- Hot water tank and tube coil made of seamless pressure vessel steel
- Electrical heating of the water via immersion heaters
- Sensors for monitoring temperature, pressure and fill level
- Visual displays for pressure, fill level and temperature
- Cathodic corrosion protection system
| MATCHCODE: | 0229V2A-0L |
|---|---|
| Funktionen:: | Der Chlorverdampifer wandelt flüssiges Chlor durch Wärmezufuhr |
| Funktion-2: | in gasförmigesa Chlor um und führt das gasförmige Chlor |
| Funktion-3: | einer Chlorgasdosieranlage zu. |
| Funktion-4: | Funktionen: |
| Funktion-5: | - Verdampferleistung bis zu 220 kg Cl2/h |
| Funktion-6: | - Rohrwendel-Verdampfer mit Wasser als Heizmedium |
| Funktion-7: | - Behälter und Rohrwendel aus nahtlosem Druckbehälter-Stahl |
| Funktion-8: | - Elektrische Beheizung des Wassers über Tauchheizkörper |
| Funktion-9: | - Sensoren zur Überwachung von Temperatur, Druck und Füllstand |
| Funktion-10: | - Optische Anzeigen für Druck, Füllstand und Temperatur |
| Funktion-11: | - Kathodisches Korrosionsschutzsystem |
* The maximum flow rate is a value determined by means of a test bench and measured with water at a liquid temperature of approx. 20 °C . The measurement is taken at the pressure joint of the pump, without hose, nozzle or flow meter. The achievable flow rate in use is lower and depends on the individual application, the liquid properties and the configuration of the pump. The max. delivery head also depends on the pump design, motor and fluid. The viscosity values are determined with oil.
** Test assembly: Medium water / diesel, flow in preferred direction, settling section 0.2 m upstream and downstream of flow meter